Kitchen Sink Drain Through Floor Or Wall

In order to do this you will have to attach the drain to the s trap below your sink where it falls into the floor including applying putty and putting drains into the base of the sink adding the tailpiece and then fitting the t.

Kitchen sink drain through floor or wall.

Drains that are in the floor are quite common. My original kitchen had a 2 bowl sink and my new kitchen will have a 30 wide sink base with a 27 wide single bowl. Sink drains that exit through the wall behind the sink require a p trap and sink drains that exit through the floor beneath the sink require an s trap. That drain tailpiece runs from the sink to the drain.

Your p trap the u or j shaped pipe is connected to the drain tailpiece. How to install drain lines through the floor. The trap arm is the horizontal piece between the u shaped trap bend. Rough in sink drain through floor.

The drain pipe fitting should be between 16 and 20 above the floor. Adding another bathroom or relocating plumbing fixtures during a remodel requires running new drainpipes. Keep in mind that the drain must maintain a minimum down slope of 1 4 inch per foot toward the sewer. If you re planning to replace a standard sink with a deep basin sink you may need to lower the drain fitting in the wall to match the lower height of the new sink drain.

Sinks should be installed approximately 31 above the floor. A single trap can service more than one sink but adjacent drains cannot be farther apart than 30 inches. Horizontal drain pipes connecting the sink drains to the trap must have a minimum slope of 1 4 inch per foot toward the trap. When you are installing a kitchen sink drain pipe along with the drain attachment on the floor you will need to be able to fit the drain and the parts together.

There also will be a garbage disposal with the new single bowl. In most communities a permit from the local. If your sink drain is located in the floor all that you need to do is reposition the p trap slightly. Drill 2 1 4 inch holes in the studs and floor plate as needed to route a 2 inch drainpipe.

There should be at least 21 of free space in front of the sink. It is my intention to remove all the in wall copper pipe and replace it with abs and somewhere in my basement i ll switch from abs back to the original copper with. The horizontal pipes connect to the trap with a double wye tee which has two y shaped inlets and one outlet. Before you buy a new kitchen sink it is a good idea to check the height of the trap arm on the old sink.